I previously posted a not so great review before I really started shadowing my tools. I had started with the very bottom layer for big tools and I was frustrated because it was difficult to dig out the foam for such a large object. But as I did the other layers for my hand tools, it was much easier and turned out great. After doing 5 or 6 layers with of tools and having to do some more big items, I had learned some tricks along the way that made it but suck so bad. If you're doing a large section that is a couple inches deep, it's best to cut around the outside, obviously, and then make long cuts to make strips that are easier to take out and just peel out like a half inch at a time. Also it's best not to cut all the way down to the backing as the sheet will lose its rigidity, but if you have to, make sure the tool is parallel to the long side. I made this mistake with my socket rails. Because they're as thick as the foam I had to cut down to the backing but I did them perpendicular to the long side and now the sheet flexes a lot when I pick it up. Hopefully it will hold up after several times of picking it up but we'll see. Overall fantastic product!
